Thursday, June 26, 2008

Bench #3 - A leg vise breakthrough

I like mechanisms that are smooth and effortless to use. And I definitely want my leg vise to work that way. After building brackets to hold my skateboard rollers, it looks like I've achieved that. The results are just what I was hoping for. The vise chop moves in and out in a perfectly straight line all along the length of the parallel guide. The chop is completely supported by the parallel guide and the rollers, not the vise screw. So the screw will turn smoothly since there's nothing pulling it down.



Here is one of the two brackets I made to hold the skateboard rollers. I used the smooth portion of a 5/16" bolt for the roller shaft (I cut the head and threads off). I locked this in position with a couple 10-24 set screws threaded into holes tapped in the flanges of the bracket. The roller is kept from rubbing the inside of the flanges by a couple washers placed between the bearings and the flanges.





The brackets attach to the legs with a couple 3/8" cap screws, tapped directly into the legs.



This is the rear bracket, on top of the parallel guide.



...with the parallel guide in place. I positioned the cap screws so there is about 1/4" vertical adjustment room.



The front bracket.



The same bracket with the parallel guide and chop.



View from underneath.



Here's a video showing how smoothly and easily the vise chop moves.

Next I'll try to devise a similar mechanism for the sliding leg vise. This poses a problem since the sliding leg vise has much less space below the parallel guide.

7 comments:

  1. You just keep thinking outside the box. Great stuff, keep it coming. I'm excited about seeing the completed bench.

    ReplyDelete
  2. I agree - one of the most novel approaches to the vise I've seen... I won't be surprised to see this idea copied quite a bit. Very well done Jameel.

    ReplyDelete
  3. Yeah, I'm pretty excited about it too. Really satisfying outcome. Now all I have to do is come up with a quick release for a wood screw and nut. Maybe that's going a little too far, but it would be slick, no?

    ReplyDelete
  4. That is just absolutely ingenious!
    I've got to go and read your entire blog now. Man! You have great talent!

    ReplyDelete
  5. That little clip illustrates how rediculously well the rollers work.

    Chris@flairwoodworks

    ReplyDelete
  6. Wow - very impressive bench and your websites are very well done too. Exceptional! Keith (www.woodtreks.com)

    ReplyDelete
  7. Thanks fellas. I've been watching your video blog quite a bit too, Keith. Great stuff.

    ReplyDelete

Note: Only a member of this blog may post a comment.